Roller axial load test bench operation instruction Qingdao

Operation instructions:
1. Supply power to the electrical control box and turn on the power switch.
2. Fix the adjusting screw on the upper cover plate and fix the sensor on the adjusting screw.
3. Place the jacks on the base, and place the roller support on the jacking telescopic bar, then place the tested roller on the roller support vertically.
4. Adjust the length of the jack and adjust the length of the sleeve according to the length of the idler (or replace the sensor mounting bolts).
5. The operating jack gradually rises until the upper roller shaft contacts with the sensor adjusting sleeve. During the lifting process, the jack position should be properly adjusted to ensure that the roller shaft axis and the sensor adjusting sleeve are in contact with each other. The centerline of the cylinder is as close as possible.
6. Operate the jack gradually and slowly until the sensor meter reading reaches the specified load of the idler (meter reading in KN).
7. Operate the jack to uninstall.
8. Check whether the roller shaft (including bearing seat and sealing device) is separated from the idler pipe. Those who have not disengaged are qualified. Otherwise, they are unqualified.

Steel Fitting

Steel Fitting,Incoloy Fitting,Inconel Fitting

YUHONG GROUP CO.,LIMITED , https://www.jessro-pipefittings.com