When a thick steel structure fireproof coating is applied to the surface of a steel component, it forms an insulating and fire-resistant layer by utilizing its non-combustible properties and low thermal conductivity during a fire. This prevents direct exposure of the structural member to the fire, significantly enhancing the fire resistance of the steel structure. The coating is non-corrosive, does not react with any anti-rust primer, has no strong odor, and is lightweight, reducing the structural load. It offers a large coverage area per unit, and in the event of a fire, it does not crack or fall off. These features make it ideal for fire protection of load-bearing steel structures in various industrial, civil, and construction projects, including new builds, expansions, and renovations. Construction Techniques for Thick Steel Structure Fireproof Coating 1. Before applying the fireproof coating, the steel component’s surface must be properly cleaned and rust-removed, ensuring that the anti-rust primer meets design specifications and national standards. All dust, oil, and debris on the steel surface should be thoroughly removed to ensure proper adhesion. 2. The fireproof coating should be applied before interior finishes are completed, and care must be taken to avoid damage from subsequent work. During the process, areas that do not require fire protection, such as walls, doors, windows, and machinery, should be covered and protected. 3. Prior to spraying, apply a steel structure interface agent. Once it is dry, the coating can be applied using either spraying or brushing. Mix the powder and emulsion in a ratio of 1:1 to create a smooth, thick fluid without lumps. Adjust the consistency based on the application method—ensuring it is easy to work with, doesn’t run, and adheres well. For very large steel components, adding a steel mesh helps prevent the coating from sagging or peeling off. 4. When using a spray gun, use a high-pressure type with an air pressure of 0.6–0.8 MPa and a nozzle diameter between 6–10 mm. Keep the spray gun perpendicular to the surface being coated, ideally at a distance of 40–60 cm for even distribution. 5. The first coat should not be too thick. Apply additional coats gradually, ensuring each layer is evenly distributed without dripping, until the desired thickness is achieved. 6. The brush application method for fireproof coating is similar to how cement is applied. Ensure even coverage and proper thickness throughout the process. Medical Industry Mass Flow Meter
Sealand is a professional manufacturer of Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter, ATEX, IECEx & CE approved.
There are 2 optical switches for operation. The SET and SELECT optical switches are used to navigate the transmitter display. To
activate an optical switch, move your finger 1~2mm over the optical switch close to the
glass.
Mark:
The general operation is listed as follows.
On Main Interfaces
Activate SET to alternate mass and volume values.
Activate SELECT to alternate main interfaces.
Long activate SELECT to go to Setup Interface.
Long activate SET for total reset.
Back to Main Interface
Long activate SET & SELECT at the same time.
Select Submenu,
Parameters & Numbers
Activate SELECT to select the submenu, parameters or
numbers.
Activate SET to go to submenu or save parameters/numbers.
Save setup
Long activate SET to save the modified setup.
Back or Exit
Long activate SELECT.
Medical Mass Flow Meter, Medical Mass Flowmeter, Medical Coriolis Meter, Medical Flow Meter, Medical Flowmeter Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com
1. The display will timeout without any operation in 5 min.
2. During numbers input, the decimal point will come up automatically if the first digit is 0; if not 0, please activate SELECT until decimal point shows up.
Characteristics and construction technology of thick steel structure fireproof coating